Shure AD1 Manual page 6

AD1 AD1 Bodypack Transmitter
Menu Map
Radio
Group Channel
Frequency
RF Power
RF Output
Audio
Pad
O set
Polarity
MuteMode
Tone
Level
Utilities
Dev ID
Lock
Marker
Battery
About
Reset All
Radio Menu
G: and C: Group and Channel
Press the enter button to enable editing of a group (G:) or channel (C:). Use
the arrow buttons to adjust the values.
Frequency
Press the enter button once to edit the first 3 digits, or twice to edit the second
3 digits.
RF Power
Higher power settings can extend the range of the transmitter.
RF Output
• On: RF signal is active
• Mute: RF signal is inactive
IR Sync
Use IR Sync to form an audio channel between the transmitter and receiver.
Note: The receiver band must match the band of the transmitter.
1. Select a receiver channel.
6/12
Audio Menu
Pad
Adjust the pad to avoid overloading the audio input. Select -12 dB or Off.
Offset
Adjust Offset level to balance mic levels when using two transmitters for fre-
quency diversity or when assigning multiple transmitters to receiver slots.
Adjustment range: -12 dB to +21 dB.
Polarity
Selectable polarity assignment for LEMO connector transmitters:
• Pos: Positive pressure on microphone diaphragm produces positive
voltage on pin 2 (with respect to pin 3 of XLR output) and the tip of the
TRS output.
• Neg: Positive pressure on microphone diaphragm produces negative
voltage on pin 2 (with respect to pin 3 of XLR output) and the tip of the
TRS output.
MuteMode
When enabled, the power switch is configured as a mute switch for the audio:
• Power switch on: audio signal on
• Power switch off: audio signal muted
Tone
Transmitter will generate a continuous test tone. The tone can be set to 400
Hz or 1000 Hz.
Level
When enabled, allows for adjustment of the output level of the test tone.
Utilities Menu
Dev ID
Assign a device ID of up to 9 letters or numbers.
Lock
Locks the transmitter controls and power switch.
Marker
When enabled, press the enter button to drop a marker in Wireless Work-
bench.
Battery
Displays battery information:
• Battery: The chemistry type of for the installed battery (Shure
Rechargeable, Alkaline, Lithium, NiMH)
• Bars: Indicates the number of bars displayed
• Time: Battery runtime
• Charge: Percentage of charge capacity
• Health: Percentage of current battery health
• Cycle: Record of the number of charging cycles for the installed battery
• Temp: Battery temperature in Fahrenheit and Celsius
About
Displays transmitter information:
• FW: Installed firmware
• HW: Hardware version
• SN: Serial number
Reset All
Restores all transmitter parameters to factory settings.
Shure Incorporated
2017/08/03