Drainage; Programming The Machine - Saeco ROYAL DIGITAL SUP015 User's And Maintenance Booklet

32
Remove the water tank (11) from the machine,
remove its cover (1 2) and fill it with cold water
(approx. 2.4 I). A valve on the tank bottom prevents
water from escaping.
Before installing the water tank in
the machine, make sure the coffee
bean container cover is properly
fitted.
26 Install the water tank, slightly pressing over it to
fit the valve which will open automatically. Replace the
cover on the tank.
Do not fill the tank with an excessive quantity
of water.
Always fill the tank with fresh water:
hot water as well as other fluids
might damage the tank.
Do not switch on the machine if the water
tank is empty. Before using the machine
make sure there is enough water in the tank.
Connect the plug to the socket and press the main
switch. The display shows WARMING UP
Should ENERGY SAVING (½) be displayed,
press the Energy saving switch to disactivate the
energy saving mode.

Drainage

Direct the steam/hot water dispensing tube (7) over
the drip tray (2). Place a cup or another suitable
container under the dispensing tube, then turn the
steam/hot water knob (9) counterclockwise. The
pump starts automatically. Wait until a regular water
jet is obtained, then close the knob. The machine is
now drained and ready to work.
The display shows
HOT WATER
READY FOR USE
DRAINAGE
Important: It is advisable to drain the machine before the
first start, after a prolonged period the machine has not
been used or whenever the water tank has been
completely emptied. Furthermore, should the pump be
defective, the display shows
Programming the
coffee machine
27 To enter the programming mode, press the key ENT
(pre-ground coffee) when the machine is on and keep it
pressed until the first two lines of the programming mode are
displayed:
LANGUAGE
WATER HARDEN
At the end of the line appears a blinking asterisk, which
can be moved up and down with the keys
regular coffee).
The display shows the following items in this
sequence:
1 LANGUAGE 6 PREGRINDING
2 WATER HARDN. 7 TOTAL COFFEE
3 CUP HEATER 8 DESCALING
4 TEMPERATURE 9 TIMER
5 PREBREWING 10 EXIT
To leave the menu, move the asterisk at the end of the
line to item «10 Exit» using the key
ENT (pre-ground coffee). The machine is now in the
normal mode again.
Selecting menu items
Select the different menu items by means of the
∧∨
keys . The key ENT allows you to activate the
selected item. It is possible to modify the selected
figures in a menu item using the keys
ENT memorizes the
VENTILATE
C (tall and
∨
. Then, press
∧∨
. The key