Installation - Porter-Cable CPLC7060V Instruction Manual

Improper electrical installation of this product may void
its warranty and your fire insurance. Have circuit wiring performed by
qualified personnel such as a licensed electricians who is familiar with
the current national electrical code and any prevailing local electrical
codes.
Location of the Air Compressor
The manifold assembly does not provide adequate
stability or support for lifting the unit. If the unit must be moved, use
the air tank for lifting.
Operate the air compressor in a clean, dry, and well-ventilated area. The air intake
filter must be kept clear of obstructions which could reduce air delivery of the air
compressor. The air compressor should be located at least 12" away from walls or
other obstructions that could interfere with the flow of air. The air compressor
crankcase and head are designed with fins to provide proper cooling.
The flywheel side of the unit should be placed toward the wall and protected with a
totally enclosed belt guard. The area should allow space on all sides for air
circulation and for ease of normal maintenance. Keep the unit away from areas
which have dirt, vapor, and combustible fumes in the atmosphere which may clog
and gum the intake filter and valves, causing inefficient operation.
If humidity is high, an air filter can be installed in line to remove excessive moisture.
Closely follow instructions packaged with the filter for proper installation. It must be
installed as close as possible to the accessory.
The air compressor should be as near to air outlets as possible in order to avoid
long pipe lines. Do not place the air compressor where heat is excessive.
Do not use an extension cord. To avoid voltage drop and power loss to the motor,
use extra air hose instead of an extension cord.
Air Compressor Anchoring Methods
(Fig. 2)
Vibration can weaken
the air tank and cause an explosion.
The AIR compressor must be
properly mounted as illustrated in
Fig 2.
This air compressor must be bolted to the
floor. Bolting holes are provided in the
base feet. Mount the air compressor on a
solid, level foundation. Support air
compressor weight evenly on all four feet.
Solid shims may be used if necessary.

INSTALLATION

3/8" Flat Washer
(not supplied)
Isolator Washer
Shim Under Isolator
Washer if Necessary
(not supplied)
8-ENG
3/8" Lag Screw
(not supplied)
Torque to 5-7 Ft.Lb.
Floor Line
Lag Screw Anchor for Concrete
(not supplied)
Fig. 2