Symmetricom SSU-2000e Technical Reference page 193

Level 2 Same as Level 1 operation
Level 3 Same as Level 2 operation, with the following additions:
INPUT xAy[-z] {ESF|D4|CCS|CAS|1MHZ|1.544MHZ|2.048MHZ|5MHZ|6.312MHZ|
10MHZ}
INPUT xAy[-z] {ZS|SSM|CRC}{ON|OFF}
INPUT xAy[-z] PRIORITY {0-10}
INPUT xAy[-z] {ENABLE|DISABLE}
INPUT xAy[-z] SSM {4|5|6|7|8}
INPUT xAy[-z] PQL {1-16}
INPUT xAy[-1] GAIN {ON|OFF}
INPUT xAy[-z] CSFLT {HIGH|LOW|OFF}
INPUT xAy[-z] {LOS|AIS|OOF|BPV|CRC}{SET|CLR} value
INPUT xAy[-z] MTIE [{EL1|EL2|CL1|CL2}]{T10|T100|T1K| T10K|T100K}
value
INPUT xAy[-z] MTIE {PRS|DS1|G.811|G.823}
INPUT xAy[-z] FREQ {A|B}{SET|CLR|TAU} value
INPUT xAy[-a] 400HZ {ON|OFF}
Allows you to change the setting of a specified Input module.
Options are:
ESF|D4
CCS|CAS
1MHZ|1.544MHZ|2.048MHZ|5MHZ|10MHZ
SSM {ON|OFF}
ZS {ON|OFF}
CRC {ON|OFF}
PRIORITY {0-10}
ENABLE
12713140-003-2 Revision E.01 – January 2007
Sets the T1 framing mode: ESF or D4. For use with the
DS1 Input module.
(For E1) Sets the E1 framing mode: CCS or CAS. For use
with the E1 Input module.
Sets the Input module clock frequency when input is not
running in framing mode. Only the clock frequencies shown
are valid. If the input is a framed T1 signal, the CLK rate is
1.544MHz; if it is a framed E1 signal, the CLK rate is
2.048 MHz automatically. For use with the DS1 or E1 Input
module.
Enables or disables Sync Status Message reading. For
use with the DS1/E1 Input module.
Enables or disables Zero Suppression. For use with the
DS1 or E1 Input module.
For DS1: On = B8ZS, Off = AMI
For E1: On = HDB3, Off = AMI
Enables or disables CRC checking. For use with the DS1
or E1 Input module.
Sets Input priority level, where: 0 = monitor,
1 = highest priority, and 10 = lowest priority. For use with all
Input modules.
Enables the specified input port on a DS1, E1, CC, or Sine
Input module.
Chapter 3 ICS Command Reference
SSU-2000e Technical Reference 193
INPUT