Enterasys RoamAbout RBT-1002 Installation Manual page 18

Introduction
LED
11a and 11b/g
(Wireless Link/
Activity)
Security Slot
The access point includes a Kensington security slot on the rear
panel. You can prevent unauthorized removal of the access point
by wrapping the Kensington security cable (not provided) around
an unmovable object, inserting the lock into the slot, and turning
the key.
Console Port
The console port is not used on the RBT-1002.
Ethernet Port
The access point has one 10BASE-T/100BASE-TX RJ-45 port
that can be attached directly to 10BASE-T/100BASE-TX LAN
segments. These segments must conform to the IEEE 802.3 or
802.3u specifications.
This port uses an MDI (i.e., internal straight-through) pin
configuration. You can therefore use straight-through twisted-pair
cable to connect this port to most network interconnection
devices such as a switch or router that provide MDI-X ports.
1-6
Status
Solid green
Slow blink
green
(2 sec on/off)
Fast blink
green
Unlit
Description
A client is associated with the radio, or
the radio is in Sweep/Sentry mode.
Radio is unable to transmit. This state
can indicate inability to send a beacon
or radio failure.
Associated client is sending or
receiving traffic.
Indicates one of the following:
• The radio is disabled
• No clients are associated with the
radio and there is no traffic activity