Setting Up The Se-2850 With The Itc-100 - Datavideo ITC-100 Instruction Manual

Setting up the SE-2850 with the ITC-100

The SE-2850 is an 8/12 channel video switcher. To set up the SE-2850 with the ITC-
100, you will need to purchase a CB-28 25pin Male D Sub to 4 x 15pin Male D Sub
Tally Cable (Part No.: G07690250002) from Datavideo.
By using the tally cable, the Tally Output of the SE-2850 can be connected to the ITC-
100 Tally Input A AND Tally Input B. The Tally Input A carries bicolor tally information
of Channels 1-4 (denoted by A on the rear panel of the ITC-100) and the Tally Input B
carries bicolor tally information of Channels 5-8 (denoted by B on the rear panel of
the ITC-100).
The channel connections to the respective ITC-100SL Belt Packs are depicted in the
diagram below.
20