Table of Contents
Advertisement
DEACTIVATING THE RINSE AID DISPENSER
While the appliance is in user mode:
1. Press Option.
•
The indicators
•
The indicator
flash.
•
The display shows the current setting:
= rinse aid dispenser activated (factory
setting).
2. Press Option to change the setting.
rinse aid dispenser deactivated.
3. Press the on/off button to confirm the setting.
ACTIVATING THE ACOUSTIC SIGNAL FOR
THE END OF PROGRAMME
By default this acoustic signal is deactivated but it
is possible to activate it.
OPTIONS
Desired options must be activated
every time before you start a
programme.
It is not possible to activate or
deactivate options while a programme
is running.
Not all options are compatible with
each other. If you have selected non
compatible options, the appliance will
automatically deactivate one or more
of them. Only the indicators of the
options still active will stay on.
MULTITAB
Activate this option when you use multi-tablets that
integrate the salt, rinse aid and detergent functions.
They can also contain other cleaning or rinsing
agents.
This option deactivates the release of salt. The salt
indicator does not come on.
With the use of this option the programme duration
is prolonged to increase the cleaning and drying
results with the use of multi-tablets.
BEFORE FIRST USE
1. Make sure that the current level of the
water softener agrees with the hardness
of the water supply. If not, adjust the level
of the water softener. Contact your local
8
and
go off.
continues to
=
While the appliance is in user mode:
1. Press Delay.
•
The indicators
go off.
•
The indicator
•
The display shows the current setting:
= Acoustic signal off.
2. Press Delay to change the setting.
Acoustic signal on.
3. Press the on/off button to confirm the setting.
Multitab is not a permanent option and must be
selected at every cycle.
How to activate Multitab
Press Option until the indicator
ENERGYSAVER
This option decreases the temperature of the last
rinsing phase and consequently also the energy
consumption (approximately -25%).
Dishes can still be wet once the programme is
completed.
The duration of the programme will be shorter.
How to activate EnergySaver
Press Option until the indicator
If the option is not applicable to the programme, the
related indicator does not come on or it flashes
quickly for a few seconds and then goes off.
The display shows the updated programme
duration.
water authority to know the water
hardness in your area.
2. Fill the salt container with special salt for
dishwasher.
and
continues to flash.
=
comes on.
comes on.
Advertisement
Table of Contents
