Table of Contents
Advertisement
Problem and alarm code
The appliance does not drain
the water.
The display shows
The anti-flood device is on.
The display shows
The appliance stops and starts
more times during operation.
The program lasts too long.
The remaining time in the dis-
play increases and skips nearly
to the end of program time.
Small leak from the appliance
door.
The appliance door is difficult
to close.
Rattling/knocking sounds from
inside the appliance.
The appliance trips the circuit-
beaker.
Refer to "Before first use", "Daily
use", or "Hints and tips" for other
possible causes.
Once you have checked the appliance, deactivate
and activate the appliance. If the problem occurs
again, contact an Authorised Service Centre.
14
•
Make sure that the sink spigot is not clogged.
•
Make sure that the filter in the outlet hose is not clogged.
•
Make sure that the interior filter system is not clogged.
.
•
Make sure that the drain hose has no kinks or bends.
•
Close the water tap and contact an Authorised Service Centre.
.
•
It is normal. It provides optimal cleaning results and energy sav-
ings.
•
An energy-saving option has been selected.
•
If the delayed start option is set, cancel the delay setting or wait
for the end of the countdown.
•
This is not a defect. The appliance is working correctly.
•
The appliance is not levelled. Loosen or tighten the adjustable
feet (if applicable).
•
The appliance door is not centred on the tub. Adjust the rear
foot (if applicable).
•
The appliance is not levelled. Loosen or tighten the adjustable
feet (if applicable).
•
Parts of the tableware are protruding from the baskets.
•
The tableware is not properly arranged in the baskets. Refer to
basket loading leaflet.
•
Make sure that the spray arms can rotate freely.
•
The amperage is insufficient to supply simultaneously all the ap-
pliances in use. Check the socket amperage and the capacity
of the meter or turn off one of the appliances in use.
•
Internal electrical fault of the appliance. Contact an Authorised
Service Centre.
Possible cause and solution
For alarm codes not described in the table, contact
an Authorised Service Centre.
Advertisement
Table of Contents
