Starting Weekly Timer Operation - Fujitsu UTB-GCA Operating Manual

6-3-2.

Starting weekly timer operation

Enter the control mode to the central control num-
ber (the indoor units) to perform the operation.
Refer to "3-3. CONTROL MODE" for information
about control modes.
TIMER
Press
MODE
on the display.
Weekly timer operation starts.
It is necessary to transmit the newly set information to the relevant indoor units.
Refer to steps 4, 5 and notes of "3-3. CONTROL MODE" for details.
Notes
To Stop Weekly Timer Operation
To stop weekly timer while leaving the air conditioner running:
TIMER
Press
MODE
To stop weekly timer operation as well as the air conditioner:
ON OFF
Press
Reviewing Time Settings
TIMER
1. Press
MODE
TIMER
2. Press
SET
DAY
3. Press
TIME
4. Press to switch between "WEEKLY1" or "WEEKLY2" time displays.
The central remote controller generates each driving pulse signal (ON or OFF) and transmits it to the
selected indoor units at (not between) each set time. The operation conditions of the selected indoor units
are controlled by these driving pulse signal.
64
until the segments of WEEKLY appear
to select NONSTOP.
(Refer to "5-2. OPERATION / STOP").
so that "WEEKLY" appears on the display.
to select setting mode.
to select the day that you want to check.