Function List - Fujitsu UTB-GCA Operating Manual

3-4. FUNCTION LIST

The following show the function list of the central remote controller. The functions shown with a
can be set following the procedures shown in "3-1. BASIC FLOW OF OPERATION". Refer to each of
the items for more detail information.
Function
Group information store
Standard remote
controller operation
prohibit setting
Memory operation
Zone setting
Filter indicator reset
All operation / All stop
Operation / Stop
Operating mode setting
Temperature setting
Fan speed setting
Flow direction setting
(vertical)
Flow direction setting
(horizontal)
Swing setting
Energy save
operation setting
Anti freeze operation
OFF timer
ON timer
Weekly timer
Notes
Beep sound:
The BEEP sound has the following meanings.
• "Beep"
This is the beep sound made when a button is operated.
• "Beep Be"
This is the beep sound when the transmission has been completed in the control mode.
• "Beep Beep Beep Beep Beep"
This is the beep sound when there has been an operating error.
• "Beep-Beep, Beep-Beep, Beep-Beep, ···"
This is the beep sound when you forget to press the transmit key when in the control mode.
18
Description of the function
Form a control unit - "group" which is combined by remote control
groups (indoor units) so that the indoor units in the same group can
be controlled simultaneously.
Standard remote controller operation prohibition setting:
Restrict the setting items of a standard remote controller.
Sets the operating limit for the standard remote control for the
assigned indoor unit.
Save the current operating conditions. The saved operating
conditions can be reproduced at any time easily.
Perform zone operation.
Reset the filter indicator after cleaned or exchanged the filter.
Operate or stop all the indoor units that have been stored to the
central remote controller.
Operate / Stop the selected indoor units.
Perform the operating mode setting of the selected indoor units.
Perform the room temperature setting of the selected indoor units.
Perform the fan speed setting of the selected indoor units.
Adjust the vertical angle of the flaps of the selected indoor units.
Adjust the horizontal angle of the flaps of the selected indoor units.
Perform auto-swing operation in vertical or in horizontal direction.
Perform the energy save operation in order to operate the system
economically.
Automatically start a heating operation to prevent the room
temperature from becoming too low and stop when the
temperature rises above a preset level.
Stop the indoor units at the set time.
Start the indoor units at the set time.
Up to two on / off settings for each day of the week.
Reference
page
P20
P23
P26
P28
P30
P32
P33
P35
P38
P39
P41
P44
P46
P50
P53
P56
P58
P60