Lenovo thinksystem SN850 7X15 Setup Manual page 65

1. Read "Installation Guidelines" on page 26 to ensure that you work safely.
2. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the
bezel pointing toward you.
Attention: You cannot insert the compute node into the Flex System chassis until the cover is installed and
closed. Do not attempt to override this protection.
To install the compute node cover, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-DtV8A4UWy7d3AoFKjCvas3
• Youku: http://list.youku.com/albumlist/show/id_50481024
Figure 40. Compute node cover installation
Step 1. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
Step 2. Orient the compute node cover so that the posts on the inside of the cover slide into the slots on
the compute node.
Note: Before you close the compute node cover, make sure that the air baffle and all components
are installed and seated correctly and that you have not left loose tools or parts inside the compute
.
Chapter 3 Compute node hardware setup
57