Table of Contents
Advertisement
Figure 33. Pressing the foam
Step 7.
Route cable back into the cable clip if the cable was removed earlier.
Figure 34. Routing the cable back into clip
After you install the RAID adapter, complete the following steps:
1. Install any removed storage drives and hard disk drive bay fillers (see "Install a 2.5-inch hot-swap drive"
on page 32).
Note: Install storage drives in the same bay locations as from which they were removed.
2. Configure the RAID array after power on the compute node (see "RAID configuration" on page 65).
Install the flash power module
Use this information to install the flash power module.
50
ThinkSystem SN850 Compute Node Setup Guide
Advertisement
Table of Contents
