Table of Contents
Advertisement
Figure 24. Processor locations on system board
Complete the following steps to install a PHM.
Watch the procedure. A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-DtV8A4UWy7d3AoFKjCvas3
• Youku: http://list.youku.com/albumlist/show/id_50481024
Step 1.
Remove the processor socket cover, if one is installed on the processor socket, by placing your
fingers in the half-circles at each end of the cover and lifting it from the system board.
Step 2.
Install the processor-heat-sink module on the system board.
.
Chapter 3
Compute node hardware setup
43
Advertisement
Table of Contents
