Table of Contents
Advertisement
• Youku: http://list.youku.com/albumlist/show/id_50481024
Step 1.
If a drive backplane is installed in the compute note that is incompatible with the interposer card,
remove it (see "Remove the 2.5-inch drive backplane" on page 52 for instructions).
Step 2.
If you are installing both the interposer card and drive backplane, first install the drive backplane in
the compute node (see "Install a 2.5-inch drive backplane" on page 31 for instructions). The drive
backplane goes in the rear alignment slots on the drive cage.
Figure 26. Drive backplane installation with backplane alignment slots
Step 3.
Touch the static-protective package that contains the interposer card to an unpainted metal
surface on any grounded rack component; then, remove the interposer card from the package.
Step 4.
Locate the interposer card connector on the top of drive backplane.
Step 5.
Orient the connector on the interposer card with the connector on drive backplane.
.
Chapter 3
Compute node hardware setup
45
Advertisement
Table of Contents
