Table of Contents
Advertisement
Unpacking
There are no special unpacking instructions. You may want to keep the shipping material for the unlikely event that the amplifier should need
returning for service.
Package Contents
• Quick-Start Guide TD-000476
• Safety Sheet TD-000420
• Amplifier
• Power Cord
Features
Amplifier Front Panel
Refer to "Amplifier Controls and Indicators" on page 8.
Amplifier Rear Panel
Refer to Figure 1 (CXD8.4Q / CXD8.8Q shown)
NOTE!: The CXD8.4Qn and CXD8.8Qn models do not have the analog inputs (Item 3 below).
1
2
1.
RJ-45 Q-SYS Q-LAN A/B
2.
GPIO Euro-style Connector, 16-pin
3.
Analog Inputs (1-8) – Eight 3-pin Euro-style Connectors (Only
CXD8.4Q and CXD8.8Q models.)
4.
Outputs (A-H) – Two 8-pin Euro-style Loudspeaker Connector
Installation
The following steps are written in the recommended installation order.
Rack-Mount the Amplifier
The CXD-Q Series amplifiers are designed to be mounted in a standard rack-mount unit. The amplifiers are 2RU high, and 381 mm (15 in) deep.
1.
Secure the amplifier in the rack with eight screws (not supplied), four in front, four in back. For complete instructions, refer to TD-000050
"Rear Rack Ears Installation Guide" which can be found on the QSC Website (www.qsc.com)
CAUTION!!: Be sure that nothing is blocking the front or rear ventilation openings, and that each side has a minimum of
2 cm clearance.
A-TD-001522-01
3
— Figure 1 —
• Euro-style Connector Plug, 3-pin (8) (CXD8.4Q and CXD8.8Q only)
• Euro-style Connector Plug, 8-pin (2)
• Euro-style Connector Plug, 3.5 mm, 16-pin (1)
4
5
5.
Cooling fan inlet (do not block)
6.
AC Power Switch
7.
Locking IEC Power Connection
8.
Rear Rack-mount Bracket
9.
Front Rack-mount Brackets
4
6
7
8
9
Hide quick links:
Advertisement
Table of Contents
