Bandwidth Requirements For Mivoice Conference/Video Phone; General Information On Ip Networking; Video Configuration - Mitel MiVoice Office 250 Manual Book

BANDWIDTH REQUIREMENTS FOR MIVOICE CONFERENCE/VIDEO
PHONE
The following table lists the bandwidth requirements for the MiVoice Conference/Video Phone,
(shown as the UC360).
CONFIGURATION
UC360 + UC360, High quality
UC360 + UC360, Low quality
UC360 + UC360 + UC360, High quality
UC360 + UC360 + UC360, Low quality
UC360 + UC360 + UC360 + UC360, High
quality
UC360 + UC360 + UC360 + UC360, Low
quality

GENERAL INFORMATION ON IP NETWORKING

For details on how to setup IP networking settings, see the MiVoice Conference/Video Phone
Engineering Guidelines.

VIDEO CONFIGURATION

When placing SIP devices into a P2P Network Group, it should be noted that the MiVoice Office
250 assumes that all devices in the same Network Group have to use the same set of codecs.
If a Network Group contains two devices that use different codecs, then these calls can result
in no media. In this case, P2P media should not be configured.
The figure below shows an example of the MiVoice Office 250 configured with an MBG to create
successful video calls.
BANDWIDTH REQUIREMENTS
(BASED ON 10 CALLS WITH EACH CALL LASTING 1 MINUTE)
3,081 Mbps per participant
1,238 Mbps per participant
5, 574 Mbps for bridge,
2,920 Mbps per participant
2,334 Mbps for bridge,
1, 150 Mbps per participant
8,860 Mbps for bridge,
2,905 Mbps per participant
3,585 Mbps for bridge,
1,214 Mbps per participant
Engineering Guidelines
35