Power Supply; Print Test Page - Intermec PR2 User Manual

Mobile receipt printer

Hide thumbs Also See for PR2:

Critical Error

Magnetic Card Reader

Standard Communication Interfaces

There are various printer configurations based on the type of communication interfaces present in the

printer.

All configurations of the printer have USB communication.

Apart from USB, one of the following interfaces will be present



Bluetooth (FCC ID: EHA-INBT01; IC ID: 1223A-INBT01)



Wi-Fi



IrDA

Power Supply

The Printer is powered by a 2-cell battery pack with 8.4V, 1620mAh capacity.

Additionally, the battery is charged by using an external AC adapter which comes along with the printer

unit.

To print a test page, press the feed button for a considerable duration (about 10 seconds) when the printer

is booting up.

Product operating temperature: -10 ~ 50 degree (discharge between -10 ~ 50 degree)

The battery charging mode to the operating temperature is only 40 degree.

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.

DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS

 Steady Red = Critical errors – cannot continue:

Door Open, Out of Paper, or Printhead is too hot

 Off = No critical errors are present.

 Flashes Green 3 times in one second = Card

was read successfully

 Flashes Red 1 time at 50% duty cycle, 1 Hz =

Card was read unsuccessfully

 Off = Card reader is not being used.

CAUTION

Pr3