General Problems - Miele PG 8083 SCVi Operating Instructions Manual

Problem solving guide

General problems

Problem
The indicator lights and
the display are dark.
Only the  indicator
flashes slowly.
The interior lighting
does not come on when
the door is opened.
The following fault is
shown in the display:

Salt reservoir lid
During the programme
the warning buzzer is
also sounding and the
In operation indicator
light is flashing.
The following fault
message appears in the
display during a
programme:

Spray arm blocked
Detergent residue is left
in the dispenser at the
end of a programme.
The detergent
dispenser lid cannot be
closed properly.
At the end of a
programme there is a
film of moisture on the
inside of the door and
the interior cabinet
walls.
52
Cause and remedy
The indicators and the display switch off
automatically to save energy (Standby mode).
 Press the  button. Standby comes to an end.
The interior lighting has been switched off
permanently.
 Switch the lighting back on again (see "Additional
functions, BrilliantLight").
The salt reservoir lid has not been closed properly.
 Close the salt reservoir lid.
If the salt reservoir lid has opened during a
programme:
 Switch the dishwasher off and then on again with
the  button.
 Start the programme again.
The middle spray arm is blocked by crockery.
 Open the dishwasher door and rearrange the items
which are obstructing the spray arm.
The spray arm jets of the middle arm are clogged.
 Switch the dishwasher off with the  button.
Then:
 Clean the spray arm (see "Cleaning and care").
The dispenser was still damp when detergent was
added.
 Make sure the dispenser is dry before adding
detergent.
Residual detergent is blocking the catch.
 Remove the detergent.
This is not a fault.
It is caused by the drying system.
The moisture will dissipate after a short while.