Toyota HILUX 1993 Repair Manual page 1071

SR–22
STEERING – Manual Gear Housing (2WD)
2. INSPECT WORM BEARINGS AND OIL SEAL
Check for wear or damage.
If a problem is found, replace the bearings, bearing races
and oil seal.
3. IF NECESSARY, REPLACE OIL SEAL
(a) Remove the oil seal with a screwdriver.
(b) Using SST, install a new oil seal.
SST 09620–30010 (09627–30010, 09631–00020)
4. IF NECESSARY, REPLACE OUTER RACE IN GEAR HOUS–
ING
(a) Using SST, remove the outer race from the housing.
SST 09612–65014 (09612–01030)
(b) Using SST, install a new outer race into the housing.
SST 09620–30010 (09626–30010, 09631–00020)
5. IF NECESSARY, REPLACE OUTER RACE 1N ADJUSTING
NUT
(a) Remove the oil seal with a screwdriver.
(b) Using SST, remove the outer race from the nut.
SST 09612–30012
(c) Using SST, install a new race into the nut.
SST 09620–30010 (09626–30010, 09631–00020)
(d) Using SST, install a new oil seal into the nut.
SST 09620–30010 (09627–30010, 09631–00020)
6. IF NECESSARY, REPLACE INNER RACE ON WORM
SHAFT
(a) Using a press, remove the inner races from the
shaft.
(b) Using SST, press new inner races onto the shaft.
SST 09620–30010 (09623–30010)
7. INSPECT SECTOR SHAFT
Measure shaft thrust clearance with a feeler gauge.
Maximum clearance: 0.05 mm (0.0020 in.) or less
If necessary, install a new thrust washer which will pro–
vide the minimum clearance between the sector shaft
and the adjusting screw.
Thrust washer thickness