How To Prepare The Machine For Operation - Clarke IMAGE 26E Operator's Manual

HOW TO PREPARE THE MACHINE FOR OPERATION

DANGER: Failure to read the operator's
manual before operating this
machine could result in injury to
you or to other personnel,
damage to the machine or to
other property as well.
CAUTION: The antifreeze solution that is
shipped in your machine will
damage carpet. Flush the
antifreeze solution from the
system before using the machine.
Your new Clarke machine has been shipped with antifreeze
solution in the machine's system. This antifreeze must
be flushed out prior to using the machine the first time.
To flush the antifreeze solution follow this procedure:
1. Plug both ends of the power cord in to the right
connection.
2. Move machine to a non-carpeted area with a floor
drain.
3. Position the machine over the drain.
NOTE: Drive wheels must be lifted off the ground
for this step.
4. Drain chemical tank completely, then add
approximately 1/4 gallon clear water to soap tank.
5. Add a minimum of five (5) gallons of clean water to the
solution tank.
NOTE: Do not use water that is hotter than 140°F.
6. Press the power switch to the "ON" position.
7. Press the accessory switch to "FLOOR" position.
8. Turn solution flow valve to maximum setting.
9. Press either of the traverse switches to activate
spray.
10. Allow the solution to run through the machine over the
floor drain until the solution tank is empty.
CAUTION: Cleaning solution in the
machine and tools can leak
onto the carpet and cause light
spots or stains. Do not leave
the extractor or other cleaning
machines or tools on the carpet
when not in use.
Clarke ® Operator's Manual IMAGE 26E Page -11-