The Controls; How To Prepare The Machine For Operation - Clarke 70831A Operator's Manual

revised 12/2013
Figure 1
Figure 2
Apply pressure to lock
Figure 3
Figure 4
Clarke Operator's Manual FM-1700HD HDTR

THE CONTROLS

The Start/Stop Levers. See fi gure 1.
The Start/Stop levers are under the handle grips.
The Interlock Switch. See fi gure 2.
The interlock switch is on the handle assembly under the Start/Stop
levers.
The Locking Lever. See fi gure 3.
The locking lever is on the bottom of the handle assembly at the back
of the machine.
HOW TO PREPARE THE MACHINE
FOR OPERATION
WARNING: Always remove the electrical plug from the
electrical outlet before installing or removing
a brush or accessory.
To connect a brush or pad driver, follow this procedure:
1. Put the handle in the vertical position.
2. To fasten the handle, press down on the locking lever.
3. Put the handle on the fl oor.
4. Put one foot on each side of the machine. See fi gure 4.
5. Fit the lugs on the bottom of the machine into the openings in
the brush.
6. Turn the brush or accessory clockwise to lock it into position.
7. Turn the brush or accessory counterclockwise to unlock and
remove the brush or accessory.
8. Lift the machine to the vertical position.
NOTE: To prevent damage to the brush or pad driver, remove
the accessory while not in use.
To connect a solution tank, follow the instructions given with the tank.
EN
ENGLISH
FORM NO. 70831A - 5