Machine Controls - Clarke IMAGE 26E Operator's Manual

THE CONTROLS
The Power Switch (See figure 1, A)
The power switch is located on the control panel.
The power switch must be on before any
function of the machine will work.
The Traverse Knob (See figure 1, B)
The traverse knob is located on the control panel just
below the power switch. The traverse knob controls the
speed of the machine. For faster speeds, turn the knob
to the right. For slower speeds, turn the knob to the left.
Variable Pump Pressure (See figure 2, C)
The variable pump pressure knob is located in the
middle of the control panel. This knob can be adjusted
clockwise to increase flow and pressure or counter-
clockwise to decrease flow and pressure. If streaking
occurs increase pressure setting.
WARNING: Do not operate the pump if the
solution tank is empty. Damage to
the pump could occur.
The Vacuum Switch (See figure 3, D)
The vacuum switch is located on the control panel to
the left of the power switch.
Accessory Switch (See Figure 3, E)
The accessory switch is located to the left of the
power switch. This switch controls where the
solution is applied - floor or accessory connection.
Clarke ® Operator's Manual IMAGE 26E
A
B
Figure 1
C
Figure 2
E
D
Figure 3
Page -7-