Safety Precautions - Samsung RHF025EE Series Installation Manual

Safety Precautions

Keep this installation manual together with the user's manual in a handy place so that you can find it whenever
you need to see it after reading this manual thoroughly.
 Make sure to read the following safety precautions carefully before installation.
 Make sure to observe the cautions specified in this manual.
 Conduct a test run of the unit after installation and then explain all system functions to the owner.
 The indications and meanings are as shown below.
WARNING
 Do not install the unit
by yourself. Incorrect
installation of the unit could
cause injury due to fire,
electric shock and water
leakage or from the unit
falling. Consult a dealer or
a qualified installer.

Hang down a blockage for
bird in front of outdoor air
suction duct. If something
such as bird's nest blocks
the air suction duct, it may
result in oxygen shortage in
indoors.
 Perform the installation
securely referring to the
installation manual.
Incomplete installation
could cause personal injury
due to fire, electric shock or
the unit falling.
 Do not attempt to repair,
move, modify or reinstall
the unit on your own. Make
sure that these installations
are carried out by qualified
personnel to avoid electric
shock or fire.
 Check if the voltage and
the frequency of the main
power supply are required
for the unit to be installed
and check the connection.
 This indicates the possibility of serious injury or death.
 The electric work must be
done by service agent or
similarly qualified person
according to national wiring
regulations and use only
rated cable. If the capacity
of the electric work is not
properly completed, electric
shock or fire may occur.

Make sure the air intake is
located far from an exhaust
port of a burner. It may
cause oxygen shortage.

Ground the unit. Do not
connect the ground to a gas
pipe, water pipe, lighting
rod or telephone grounding.
Defective grounding could
cause electric shock.
 Install the cables with
supplied cables firmly.
Fix them securely so that
external force is not to exert
to the terminal board.
If the connection or fixing is
incomplete, heat generation,
electric shock or fire may
occur.
 Install separate MCCB and
ELB when installing the
power cable. If you do not
install the MCCB and ELB,
electric shock or fire may
occur.
 If the power plug is
damaged, replace it by the
manufacturer or qualified
personnel to avoid the risk.

Disconnect the circuit
breaker when you don't use
the product for a long period
of time to save energy.

Do not install the electric
wire to get tension to avoid
a hazard.
 Unplug the product before
get repaired.
 Do not pull the electric wire
or touch the power plug
with wet hands.
 Installers are required to
read the general information
carefully for safety.
 Do not put the product near
dangerous substances to
prevent fire, explosion or
injury and do not expose the
product to direct
sunlight.
3
E-