Commands And Responses; Using The Command And Response Table; Symbol Definitions - Extron electronics VoiceLift Pro VLS 3001 User Manual

Commands and Responses

Using the Command and Response Table

The
•
•
•
The ASCII to hexadecimal conversion table below is for use with the command and
response table:
Space
Upper- and lowercase characters can be used interchangeably in the command field unless
otherwise specified.

Symbol Definitions

E
Command and Response Table for SIS Commands
Valid ASCII command codes
The receiver responses to the host
A description of the command function, or the results of executing the command
ASCII to Hex Conversion Table
] = Carriage return and line feed (
= Carriage return with no line feed
}
| = Pipe (can be used interchangeably with the
= Space
•
= Escape key
= Can be used interchangeably with the
W
X@ = On and Off status
0 = off/disable/open (default)
1 = on/enable/closed
= Firmware version number
X#
= Verbose mode
X$
0 = disabled
1 = verbose mode (default)
2 = tagged responses for queries
3 = verbose mode and tagged responses for queries
= Pulse time in 256 ms counts
X%
If parameter is missing or = 0, then the pulse length is default = 2 = 512 ms.
Max = 255 65280 ms ≈ 65 seconds
= Relay
X&
1 = Relay 1
2 = Relay 2
= Chime
X*
0 = Off
1 = On (default)
VoiceLift Pro Microphones User Guide • SIS Configuration and Control
on page 28 lists the following:
•
)
LF
}
character).
E character.
27