Table of Contents
Advertisement
VLH 302 Handheld Microphone
1.
2.
3.
4.
Pairing the Microphones with the VLR 302
Follow the steps below to pair microphones with a receiver, if necessary.
Verify which Microphones are Paired
Before pairing new microphones, follow these steps to verify which microphones are already
paired:
1.
2.
Pair New Microphones
Follow the steps in this section to pair microphones to the VLR 302 receiver.
NOTES:
1.
Verify that the battery is installed and fully charged.
Turn the microphone on by sliding up the power
switch (see
at right).
A
NOTE: Each VLM kit includes microphones
and a VLR 302 receiver that have already
been paired. If there is a need to pair a
microphone, follow the steps in the next
section, below.
Speak in a normal tone of voice, adjusting the
volume level as necessary. The volume buttons are
located under the microphone cover (see
When finished, return the microphone to the charging station.
Ensure that the microphones are fully charged. Power
each microphone on, one at a time, to determine if the
microphones are paired to the VLR 302 receiver.
NOTES:
•
As each microphone is powered on, one of
the VLR link slot LEDs (see
illuminate if the microphone is paired.
•
Only one microphone can be paired to each
LINK slot on the VLR receiver.
Once you have determined which microphones are
paired, turn them off.
•
All paired microphones must be turned off before pairing new microphones.
•
If adding a new microphone to the system (or replacing a current microphone), and
both LINK slots are currently assigned, reset the VLR 302 to clear the paired history
(see
Resetting the VLR 302
•
Clearing the paired history removes microphone LINK information from the VLR 302.
All microphones must be paired again, including any microphone that was previously
paired.
Press and hold the LINK button on the VLR 302 receiver (see
start pairing mode. If LINK slots are available, one of the LINK LEDs blinks to indicate that
pairing mode has started.
VoiceLift Pro Microphones User Guide • VLM Kit Installation and Operation
A
at right).
B
at right) will
A
on page 32 for reset options).
+
B
VLH 302
(Cover Removed)
A B
above) for 4 seconds to
B
14
Advertisement
Table of Contents
