Step 3 - Install The Pvs 407D Switcher; Polevault Switcher Installation - Extron electronics VoiceLift Pro VLS 3001 User Manual

Step 3 — Install the PVS 407D Switcher
The PVS 407D PoleVault Switcher receives input video and audio signals from the AV
source input wallplates, and audio signals from the VoiceLift VLR 302 receiver. It outputs and
switches the video and audio signals to a display and speakers. For details, see the PoleVault
Digital Systems Installation Guide (Featuring the PVS 407D Switcher), included with the
switcher and available at www.extron.com.
1/2
SIG LINK
POWER
12V
3A MAX
PVT IN
Power Supply Connector
Figure 8.

PoleVault Switcher Installation

1.
2.
3.
PoleVault Switcher Location
The PoleVault switcher can be mounted anywhere in the room. However, placing the switcher
near the ceiling makes cabling and upgrading to a full PoleVault system easier. WallVault
and PlenumVault options are also available for wall or plenum ceiling mount applications (for
installation instructions, see the installation guides for each system).
WARNING:
AVERTISSEMENT : Un défaut dans la structure du plafond pourrait provoquer des
Possible switcher mounting locations include:
•
•
•
•
OUTPUT
INPUTS
3/4
5
6
SIG LINK
PVT IN HDMI HDMI
PVS 407D Switcher
Determine a location within the room for the PVS 407D switcher (see PoleValut Switcher
Location below).
Install the PVS 407D, following the instructions in the PoleVault Digital Systems Installation
Guide (Featuring the PVS 407D Switcher) and the provided mounting kit user guide.
Make sure that the PVS 407D front and rear panels are accessible until installation and
testing of the VoiceLift System is complete.
Structural ceiling failure could cause serious injury or death. Check the
structural ceiling to ensure that it can handle a load four times the weight of the final
setup.
blessures graves voire mortelles. Vérifier la structure du plafond afin de vous assurer qu'il
peut supporter une charge quatre fois supérieure au poids de l'installation finale.
Table top, cabinet, or shelf (attach the four provided rubber feet to the bottom of the unit)
Under a desk
Mounted to a wall with an Extron WMK 160 or USFM 100 WallVault Wall Mount Kit
Above a drop ceiling using the Extron PlenumVault PVM 220
VoiceLift Pro Microphones User Guide • VoiceLift System Installation
Output to Speaker
PVS 407D
AMPLIFIED AUDIO OUT
DO NOT L
GROUND
OR SHORT
4/8
SPEAKER
OUTPUTS
CLASS 2 WIRING
REMOTE
RS-232
Tx Rx
VoiceLift Receiver Port
Audio Out
Paging Sensor Port
Port
AUDIO OUT LAN LAN
PAGING
SENSOR 1 3
R
L R
+V
OVER PVT INPUT 7 AUX
IR L R
G S G
2 4
23