Table of Contents
Advertisement
SIRIUSRadio.book Page 8 Tuesday, November 21, 2006 5:15 PM
Adding a Device by Entering Its
Code
You can add a device by manually
entering its manufacturer's code. See
"Manufacturer's Codes" on page 30.
To add a device by entering its code,
perform the following steps:
1.
Press and hold SET until the
remote displays Initial Setup.
2.
Press OK. The wireless controller
displays Add Device. The bottom
line of the display lists Receiver as
the first device you can add.
Press OK to add your receiver.
3.
Enter the four-digit code for your
device (for example, 1967). You
can find the code list for receivers
at the end of this user guide. (See
"Manufacturer's Codes" on
page 30.) The LED blinks once
for each digit entry. It blinks twice
after the you have entered the
final digit.
4.
Your receiver turns off if the code
was successful.
5.
Press OK to save the code.
Repeat the steps above for each
device you want to add.
Adding a Device by Searching
for Its Code
To add a device by searching for its
code, perform the following steps.
1.
Press and hold SET until the
wireless controller displays Initial
Setup.
2.
Press OK. The wireless controller
displays Add Device. The bottom
line of the display lists Receiver as
the first device you can add.
Press OK to add your receiver.
3.
The remote displays the device
name on the top line and Code
Setup on the next line. Press
Scroll Left ( ) or Scroll Right
( ) to scroll through the
manufacturer's codes for your
receiver. When you have selected
8
the correct code, the wireless
controller turns off the receiver.
4.
Press OK to save the code for
your receiver.
Controlling Your Stereo's
Volume and Setting Its Audio
Source Using Your Wireless
Controller
NOTE: You must first set up your
wireless controller to control your
stereo receiver before setting it to
control the receiver's volume.
Make sure you can control
volume using the wireless
controller before connecting the
IR Blaster to your receiver. If you
cannot add a device using its
code setup, try having your
wireless controller learn the setup
from another remote control (See
"Replacing a Device" on
page 22.)
To set up your wireless controller to
control your stereo's volume, perform
the following steps:
1.
Connect the 6-foot SIRIUS IR
Blaster cable to your stereo's
infrared remote control window.
To make this connection, pull the
backing from the end of the cable
and stick the end of the cable
onto your stereo's infrared remote
control window.
NOTE: If you cannot find your
stereo's infrared window, try
shining a flashlight at your stereo
to find the infrared "eye."
2.
Press OK to exit SIRIUS mode,
then press and hold SET until the
LCD displays Initial Setup.
3.
Press Scroll Left ( ) or Scroll
Right ( ) until the LCD displays
Advanced Setup.
4.
Press OK.
5.
The wireless controller displays
SELECT AUDIO DEVICE AND PUSH OK.
Press Scroll Left ( ) or Scroll
SIRIUS Conductor Tuner
Advertisement
Table of Contents
