JR XP810-3 Manual page 89

4.1 3 Programmable Mixing 1-3 (Function Mode), cont.
Channel display
THRO:
AILE:
ELEV:
RUDD:
GEAR:
PIT:
AUX 2:
AUX 3:
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
To Program Mixing #1
To Gyro Sensitivity
Adjustment function
Programmable Mix #3
Programmable Mix #3 is similar to the previous mixes, with the
exception that there are only 3 positions where output values
can be adjusted.
As in the previous mixes, the first channel is considered the
master channel, with the second channel selected as the slave
channel.
Master channel
Slave channel
Throttle
Aileron
Elevator
Rudder
Channel 5
Pitch/Aux 1
Aux 2
Aux 3
Press the DN and Select keys
simultaneously to access the
Function Mode List Display
UP
DN SELECT
Press to move
cursor after
mix has been
activated
www.modelflight.com.au
Programmable Mix #1 & #2
Control stick input value
Mix point to be adusted
CH CH
Press either CH Press either + or - key
key to program the to select the
Master/Slave Master/Slave channels,
channels, or to to turn exponential On
move the cursor to or Off, and to select
any of the 5 points the Mixing Switch type
(L, 1, 2, 3,H)
This mix can be set in the computer and remain on at all times,
or it can be switched on and off in flight using a number of
different switches.
Programmable Mix #3 uses a high and low mixing value
adjustment, as well as a mixing offset value to redefine the
neutral position of the slave channel.
HELI 89
– World's best source of JR products
Point number (L, 1, 2, 3, H)
Mixing value (max ± 100)
Mixing switch type selected (ON, F-NR, F-S12, F-S2)
Mixing value of existing stick postition
CLEAR
Press to reset the
value to the factory
preset at the cursor