JR XP810-3 Manual page 77

4.6 Stunt Trim (Function Mode), cont.
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
To Throttle Hold
function
To Travel Adjust
function
4.7 Throttle Hold (Function Mode)
The Throttle Hold Function holds the throttle servo in a specific
position when the switch is activated. This is very useful for
practicing autorotation landings. The throttle hold switch is
located on the top right corner of the transmitter. The throttle hold
function is ON in the forward switch position; in the rear
position, the throttle hold function is OFF.
The factory setting for the throttle hold is inhibited. Pressing either
the + or - key will adjust the throttle hold value.
Press either + or - key to
activate and
Increase/Decrease value
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
To Throttle Curve
function
Press the DN and Select keys
simultaneously to access the
Function Mode List Display
UP DN SELECT
Press the DN and Select keys
simultaneously to access the
Function Mode List Display
UP
DN SELECT
To Stunt Trim
function
www.modelflight.com.au
CH CH
Press to move
Press to increase or
the arrow to the
decrease the mixing
channel to be
value ( ±125%)
adjusted
Using the + or - key, adjust the throttle hold value to deliver the
proper engine RPM for your helicopter. The adjustable range is
--20 through +50%. To shut the engine off during an
autorotation, a negative value may have to be input.
In Function Mode, use the UP and DN keys to select Thottle
Hold and access by pressing the UP and DN keys
simultaneously.
or CLEAR
ON
CH CH
Press either the +
or - keys to set the
Throttle Hold value
(-20% – +50%)
HELI 77
– World's best source of JR products
CLEAR
Press to reset the
mixing value at the
arrow to the factory
pre-set (0) or to
inhibit the Stunt
Trim function
Initail setting
(inhibit)
Press CLR key to
inhibit the Throttle
Hold function
When the Hold switch
is in the "ON" position,
the display flashes "ON"
Throttle Hold Position
Value (-20 – +50%)
CLEAR
Press CLR to return
the Throttle Hold
function to the
factory pre-set
inhibited (Off)
position