Dispenser Trim - GE ZISB420DH Manual

GE Monogram
®

DISPENSER TRIM

Freezer Door
Ice/Water Dispenser
3/4" Flush Panel
3/4" OVERLAY PANEL DISPENSER TRIM
A
RAISED PANEL DESIGN ON DISPENSER MODELS
16 3/4"
10 5/8"
DISPENSER TRIM
42" Built-In Side-by-Side Refrigerator
3/4" Flush Panel
3/4"
Total
Thickness
B
C
SIDE VIEW CROSS SECTION
(Showing Raised Panel with
Middle Rail)
ZISB420DH
FLUSH INSET INSTALLATION
NOTES
These refrigerators are supplied with a
dispenser trim for flush inset panels.
A 3/4" Panel Dispenser Trim:
The provided dispenser trim is designed
to fit a total panel thickness of 3/4".
• If the panel is less than 3/4" thick, a
noticeable gap may be created around the
dispenser trim.
• If the panel is more than 3/4" thick, the
dispenser trim cannot be secured to the
door.
• The overlay panel must be constructed
according to the specifications shown to
achieve the correct total thickness.
• When a raised panel design is to be used, a
custom middle rail is required.
Raised Panel Design on Dispenser Models:
When a raised panel design is to be used, a
custom wide middle rail is required to accept
the dispenser trim.
B • The middle rail must be wide enough to
allow for the dispenser trim to overlap
the opening.
C • The middle rail must be 3/4" total
thickness to accept the dispenser trim.
Product Specification Revised 10/14