22
AP-6511 Access Point Installation Guide
The WAN Configuration screen is partitioned into WAN Interface and Gateway fields.
19. Set the following WAN Interface information:
• WAN IP Address/Subnet - Enter an IP Address and a subnet for the AP-6511's WAN
interface. If the Use DHCP checkbox is selected, this field is not available.
• Use DHCP - Select the checkbox to enable an automatic network configuration using a
DHCP server. If this option is enabled, the WAN IP Address/Subnet and Gateway fields
are populated by the DHCP server.
• What VLAN ID should be used for the WLAN interface? - Use the spinner to select the
VLAN ID to associate with the WAN Interface. The default setting is VLAN 2100.
• What port is connected to the external network? - Use the drop-down menu to select the
physical port that's connected to the WAN interface.
• Enable NAT on the WAN Interface - Select the checkbox to allow traffic to pass between
the WAN and LAN interfaces.
20. Enter an IP Address for the AP-6511's Default Gateway on the WAN interface. If the Use
DHCP checkbox is enabled, this field is not configurable.
21. Select Next to continue to the WLAN Setup screen.