Table of Contents
Advertisement
3.1.3 Removing the CD changer unit
(See Fig. 4 to 7)
• Prior to performing the following procedure, remove the metal
cover and CD tray fitting.
(1) Remove the card wire attached to CD changer unit on the
adhesion tape.
(2) Disconnect the card wire from the connector
CD board.
(3) Disconnect the harness from the connector
main board.
(4) Remove the two screws C attaching the CD changer unit to
the rear panel.
(5) Remove the two screws D attaching the CD changer unit to
both sides of the front panel assembly.
(6) Draw the CD changer unit upward from behind while pull-
ing the rear panel outward.
CW105
on the
Adhesion tape
CW104
on the
CW105
Front panel
assembly
D
(both sides)
Card wire
CD changer unit
Fig.4
Fig.5
C
Fig.6
CD changer unit
Fig.7
CD board
CD changer unit
CW104
Main board
Rear panel
Rear panel
(No.MB080)1-7
Advertisement
Table of Contents
