Table of Contents
Advertisement
3.3
CD changer unit
• Prior to performing the following procedure, remove the CD
changer unit.
3.3.1 Removing the CD tray
(See Fig. 1 and 2)
(1) Turn the black loading pulley gear on the under side of the
CD changer unit in the direction of the arrow and draw the
CD tray toward the front until it stops.
(2) Disconnect the card wire from connector
board.
(3) Push down the two tray stoppers marked a and pull out the
CD tray.
3.3.2 Reinstall the CD tray
(See Fig. 3 and 4)
(1) Align the gear-cam with the gear-tray as shown fig.3, then
mount the CD tray.
(2) When assembling the CD tray, take extreme care not en-
gage with gear - synchro.
Gear-cam
Gear-convert
Gear-convert
Gear-tray
1-12 (No.MB080)
CW103
on the CD
Gear-tray
Gear-cam
timing point
Gear-tray
Fig.3
Loading pulley
gear
CD tray
a
(Tray stopper)
CD tray
CD tray
CD board
CW103
Fig.1
a (Tray stopper)
CW103
(on the CD board)
Fig.2
Gear-synchro
Fig.4
Advertisement
Table of Contents
