Tools Included; Need Help - Vision Fitness T80 Owner's Manual

CONSOLE (TOUCH CONSOLE SHOWN)
IN REACH CONTROLS
WATER BOTTLE HOLDER
CONSOLE MAST
ON/OFF SWITCH
CIRCUIT BREAKER
POWER CORD
TRANSPORT WHEEL
SUPPORT BAR
20
USB PORT AND IPOD CORD (TOUCH CONSOLE ONLY)
SAFETY KEY PLACEMENT
GRIP PULSE BARS
MOTOR COVER
SIDE RAIL
BELT / RUNNING DECK
ROLLER END CAP
REAR ROLLER TENSION
& ADJUSTMENT BOLTS
pRE-assemBlY

TOOlS INClUdEd:

F 8 mm T-wrench
F 6 mm T-wrench
F 5 mm T-wrench UNpACkING
F 5 mm l-wrench
F 4 mm l-wrench Place the treadmill carton on a level flat surface. it is recommended that you place a
protective covering on your floor. Take CauTion when handling and transporting this
F 13 mm Hex wrench
unit. once the banding straps have been removed, do not transport this unit unless it is
F screwdriver
fully assembled. unpack and assemble the unit where it will be used. never grab hold of
any portion of the incline frame and attempt to lift or move the treadmill. lift the treadmill
pARTS INClUdEd:
from the roller end caps area while a second person removes the parts packed under
F 2 Console masts
the treadmill.
F 2 Handlebars
F 2 support Bars
F 2 support Bar Caps
WARNING
F 2 sets Base Frame Covers
F 1 Console Base
do noT aTTemPT To liFT THe TReadmill! do not move or lift treadmill
F 1 Console Base Cover
F 1 water Bottle Holder
from packaging until specified to do so in the assembly instructions. You may
F 1 accessory Holder
remove the plastic wrap from console masts.
F 1 Hardware Kit
F 1 Power Cord
WARNING
FailuRe To Follow THese insTRuCTions Could ResulT in inJuRY!

NEEd HElp?

if you have questions or if there noTe: during each assembly step, ensure that all nuts and bolts are in place and
partially threaded in before completely tightening any one bolt.
are any missing parts, contact
your authorized Vision Fitness
noTe: a light application of grease may aid in the installation of hardware. any grease,
retailer.
such as lithium bike grease, is recommended.
21