Yamaha MMP1 Operation Manual page 19

Monitor Matrix Out
Name (Label) Displays Monitor Matrix Out names.
NOTE
• The breakdown of Monitor Matrix Out is
based on the format selected in the
"Monitor Matrix" tab of the "Scene" tab on
the Settings screen.
• You can add Monitor Matrix Out names
(labels) in the "MISC" tab of the "Scene"
tab on the Settings screen.
Trim Double click or use the mouse wheel to
adjust output levels. Out-of-range values
entered will be corrected to the maximum or
minimum value allowed.
NOTE
When the Cue and Studio Speaker format is
set to stereo, the same settings will be
applied to both L/R.
Monitor matrix
• Click to turn Send on (green) or off. When a cell has
been turned on, a signal will be sent from the cell row
(the input source) to the cell column (output).
• To turn multiple cells on or off at the same time,
simultaneously hold down the right mouse button
(Windows) or the <control> key (Mac) and then drag
and release the button (key).
Quick Assign: Criss cross from dragging origin point
On: Turns entire dragged area on (green)
Off: Turns entire dragged area off
• Right click (Windows), or hold down the <control> key
and then click (Mac) on a cell that has been turned on
(appearing in green) to set Send levels. Out-of-range
values entered will be corrected to the maximum or
minimum value allowed.
• If the input source is the channel strip (Ch 1-8), right
click (Windows), or hold down the <control> key and
then click (Mac) to select either "Mono," "L," or "R."
• If the Monitor Source format has been selected in the
"Monitor Matrix" tab of the "Scene" tab on the Settings
screen, you cannot set Monitor Sources 1-8 to send to
the Main Monitor, Downmix L/R, or Headphone L/R on
this screen.
Use the "Monitor Control" tab on the Main screen to turn
these Send signals on or off (described in detail below).
Send signals to the Main Monitor: Use the "Monitor
Source" selection button to turn Send on or off.
Send signals to Downmix L/R: Use the "Monitor
Source" selection button to turn Send on or off.
Send signals to Headphone L/R: Set the target to
headphone output, and then use the "Monitor Source"
selection button to turn Send on or off.
4. Screens
MMP1 Operation Manual 19