Table of Contents
Advertisement
To view the current switch speed:
From the Root menu, type show sysinfo and press E
Setting the system switching mode (root/config/sys/mode)
This command sets the switching or segmenting capability of the device, which allows
increased aggregate bandwidth and decreased latency by only routing data between
opened ports. The default setting is on (enabled).
Disabling the switching capability places the switch into a single shared loop (FC-AL
loop mode) similar to a Fibre Channel hub. In this mode, all port policies are disabled
and the ports share bandwidth.
To change the switch mode:
From the System Configuration menu (root/config/sys), type mode <setting> and
press E
Table 6. System switching modes
Setting
1
2
To view the current switch mode:
From the Root menu, type show sysinfo and press E
Configuring the OS Error Threshold (root/config/sys/oserr)
The Ordered Set Error Threshold is the maximum number of OS errors allowed in a 10-
second interval before a port is bypassed. Setting this value to '0' returns the threshold
to the factory default setting. The default setting is 16777215.
To change the threshold:
1. From the System Configuration menu (root/config/sys), type oserr and press
2. Type the new value and press E
To view the current OS Error Threshold:
From the Root menu, type show sysinfo and press E
12
2006 Model L10 Storage Switch
.
NTER
Description
Set switch mode to on (enabled).
Set switch mode to off (disabled).
E
.
NTER
The current value appears in brackets before the command prompt.
NTER
NTER
. The valid range is from 0 to 16777215.
NTER
NTER
.
.
.
Advertisement
Table of Contents
