Wheel Replacement - Pride Mobility raptor series Owner's Manual

V I I I . C A R E A N D M A I N T E N A N C E
Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in your
ability to perform the maintenance listed below, you may schedule inspection and maintenance at your
authorized Pride Provider. The following areas require periodic inspection and/or care and maintenance.
TIRE PRESSURE
„ If equipped with pneumatic tires, always maintain the psi/bar/kPa air pressure rating indicated on
each tire.
WARNING! It is important that the psi/bar/kPa air pressure rating indicated on each tire be maintained
in pneumatic tires at all times. Do not underinflate or overinflate your tires. Low pressure may result
in loss of control, and overinflated tires may burst. Failure to maintain the psi/bar/kPa air pressure
rating indicated on the tires at all times may result in tire and/or wheel failure.
„ Regularly inspect your scooter's tires for signs of wear.

WHEEL REPLACEMENT

Contact your authorized Pride Provider for replacement tires.
EXTERIOR SURFACES
Bumpers, tires, and trim can benefit from an occasional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the scooter's vinyl seat or tire tread, as this
may cause them to become dangerously slippery.
CLEANING AND DISINFECTION
„ Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your
scooter. Avoid using products that may scratch the surface of your scooter.
„ If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for
use on your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or cleaning
agent before applying it to your product. Failure to comply may result in skin irritation or premature
deterioration of upholstery and/or scooter finishes.
BATTERY TERMINAL CONNECTIONS
„ Make certain that the terminal connections remain tight and uncorroded.
„ The batteries must sit flat in the battery wells.
„ The battery terminals should face away from the seat post.
WIRING HARNESSES
„ Regularly check all wiring connections.
„ Regularly check all wiring insulation, including the charger power cord, for wear or damage.
„ Have your authorized Pride Provider repair or replace any damaged connector, connection, or
insulation that you find before using your scooter again.
PROHIBITED! Even though the scooter has passed the necessary testing requirements for ingress
of liquids, you should keep electrical connections away from sources of dampness, including direct
exposure to water or bodily fluids and incontinence. Check electrical components frequently for
signs of corrosion and replace as necessary.
WARNING! Do not pull on electrical harnesses directly to detach them from the scooter. Always
grasp the connector itself when disconnecting the harness to prevent wire damage.
26
Raptor