Dvd Mechanism; Removing The Traverse Mechanism; No.mb711<Rev - JVC NX-D7UX Service Manual

3.2

DVD mechanism

3.2.1 Removing the traverse mechanism

(See Fig.1 to 4)
(1) Remove the one screw A attaching the Front end board.
(See Fig.1)
(2) Remove the two screws B attaching the tramecha holder
from top side of DVD mechanism assembly. (See Fig.2)
(3) Remove the four screws C attaching the traverse mecha-
nism. (See Fig.3)
(4) Solder the solder part of DVD pick up. (See Fig.4)
(5) Disconnect the card wire from
DVD module board. (See Fig. 1)
Caution:
• Solder the short land section on the DVD pickup before dis-
connecting the card wire from the connector on the DVD
pickup. If the card wire is disconnected without attaching sol-
ders, the pickup may be destroyed by static electricity.
• When attaching the DVD pickup, be sure to remove solders
from the short land section after connecting the card wire to
the connector on the DVD pickup.
CN101
CN101 and CN201
A
CN201
Fig.1
on the
Traverse mechanism assembly
C
B
Clamper base
B
DVD mechanism assembly
Fig.2
DVD mechanism assembly
Fig.3
Solder short land section
Fig.4
(No.MB711<Rev.002>)1-13
C