Removing The Power Board; Removing The Fl Board; Removing The Touch Sensor Board; Removing The Mic Board And Usb Board - JVC NX-D7UX Service Manual

(2) Remove the one screw N attaching the Voltage selector
board. (See Fig.14)
N
3.1.8 Removing the Power board (See Fig.15)
(1) Disconnect the Power cord connected to connector
the Power board.
(2) Remove the four screws P attaching the Power board.
P
3.1.9 Removing the FL board (See Fig.16)
(1) Remove the three screws Q attaching the FL board.
Q
Fig.14
P
CN1
Fig.15
Q
Fig.16
3.1.10 Removing the Touch sensor board (See Fig.17, 18)
(1) Disconnect card wire from LED board connected to con-
nector CN920
(2) Remove the four screws R attaching the Volume board.
(See Fig.17)
R
R
(3) Remove the two screws S attaching the Touch sensor
CN1 of
board. (See Fig.18)
CAUTION:
The touch sensor board sticks to a front lens.
3.1.11 Removing the Mic board and USB board (See Fig.19,
20 and 21)
(1) Remove the two screws T attaching the Slide door.
(See Fig.19)
of the Volume board. (See Fig.17)
CN920
Fig.17
S
S
Fig.18
T
Fig.19
(No.MB711<Rev.002>)1-11