Table of Contents
Advertisement
2.4 Factory Reset Button
The Router may be reset to the original factory default settings by depressing the reset
button for a few seconds while the device is powered on. Use a ballpoint or paperclip to
gently push down the reset button. Remember that this will wipe out any settings stored
in flash memory including user account information and LAN IP settings. The device
settings will be restored to the factory default IP address 192.168.1.1 and the subnet mask
is 255.255.255.0, the default management Username is admin and the default Password is
admin.
2.5 USB Installation
To connect the DSL router to the PC's USB port, perform the following:
Connect the USB cable to the USB port on the DSL router. The cable has two different
connectors; you may have to try both connectors and the connector is keyed so try
different orientations.
Connect the other end of the USB cable into the PC's USB port. For the USB installation
on Windows XP, once the PC powers up, a message tips shows Found new hardware on
the system tray.
Then a dialog window Found New Hardware Wizard pop-up, Select Install the software
automatically (Recommended) and insert the Manual and Driver CD-Rom. Click <Next>,
12
Advertisement
Table of Contents
