JVC KW-XC88 Service Manual page 45

QQ
3.1.6 Removing the CD mechanism assembly 3 7 63 1515 0
(See Fig.9)
• Prior to performing the following procedures, remove the front
panel assembly, rear bracket, heat sink, top chassis assembly,
main board and CD mecha control board.
(1) Remove the three screws J attaching the CD mechanism
assembly to the top chassis assembly.
Reference:
When attaching the CD mechanism assembly, joint the hole of
the CD mechanism assembly in boss d and boss e of the top
chassis assembly.
3.1.7 Removing the changer control board
(See Fig.10, 11)
• Prior to performing the following procedures, remove the front
panel assembly, rear bracket, heat sink, top chassis assembly
and bottom chassis assembly.
(1) From the back side of the bottom chassis assembly, dis-
connect the card wire from the connector
changer control board. (See Fig.10)
(2) From the top side of the bottom chassis assembly, remove
TE
L 13942296513
the two screws K attaching the changer control board. (See
Fig.11)
Reference:
When attaching the changer control board, joint the hole of the
changer control board in joints f of the bottom chassis assem-
bly.
www
.
http://www.xiaoyu163.com
CN972
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
CD mechanism assembly
J
Boss d
Changer control board
on the
Q Q
3 6 7 1 3 1 5
Bottom chassis assembly
Bottom chassis assembly
K
Changer control board
co
.
9 4 2 8
Boss e
J
Top chassis assembly
Fig.9
CN972
0 5 8 2 9 9 4 2 8
Card wire
Fig.10
Cassette mechanism assembly
Joints f
Fig.11
m
(No.MA099B)1-9
9 9
J
9 9
K