JVC KW-XC88 Service Manual page 20

QQ
3.3.8 Removing the head / tape guide 3 7 63 1515 0
(See Fig.16 and 17)
REFERENCE:
It is not necessary to remove the slide chassis assembly.
(1) Remove the band attaching the wire to the head.
(2) Remove the two screws B, the head and the head support
spring.
(3) Remove the pinch arm spring from the tape guide.
(4) Remove the tape guide and the pinch spring arm.
CAUTION:
When reattaching the pinch arm spring, set both end of
it to the pinch spring arm (remarked o).
CAUTION:
When reattaching the head, set the wires into the groove
of the tape guide (Fig.16).
3.3.9 Removing the flywheel assembly (F) & (R)
(See Fig.18 and 19)
REFERENCE:
It is not necessary to remove the slide chassis assembly.
(1) Remove the belt at the bottom.
(2) Remove the two polywashers on the upper side.
(3) Pull out each flywheel assembly downward.
Slide chassis assembly
TE
L 13942296513
Head
Fig.15
Head
Head support spring
Tape guide
o
Pinch spring arm
www
.
Slid chassis assembly
Fig.16
1-20 (No.MA099)
http://www.xiaoyu163.com
B
Tape guide
B
Pinch arm spring
o
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Flywheel assembly (F)
Flywheel assembly (R)
Q Q
3 6 7 1 3 1 5
Flywheel assembly (F)
co
.
9 4 2 8
Belt
Fig.17
Polywasher
Polywasher
0 5 8 2 9 9 4 2 8
Flywheel assembly (R)
Fig.18
m
9 9
9 9