TP-Link Archer VR600v User Manual page 116

Chapter 14
4. Click Add to add a new static routing entry. Finish the settings
according to the following explanations:
• Network Destination:
want to assign to a static route. This IP address cannot be on
the same subnet with the WAN IP or LAN IP of the router. In
the example, the IP address of the company network is the
destination IP address, so here enters 172.30.30.1.
• Subnet Mask: Determines the destination network with the
destination IP address. If the destination is a single IP address,
enter 255.255.255.255; otherwise, enter the subnet mask of
the corresponding network IP. In the example, the destination
network is a single IP, so here enters 255.255.255.255.
• Gateway: The IP address of the gateway device to which the
data packets will be sent. This IP address must be on the
same subnet with the router's IP which sends out the data. In
the example, the data packets will be sent to the LAN port of
Specify Your Network Settings
The destination IP address that you
111