Operation In Man Mode (Manual Mode) - Profoto A1 User Manual

• Lights in group C are turned off
• Group D has no offset and will be 0.8 f-stops less than lights in
group A and 1.8 f-stops more than lights in group B
•
The modeling light is turned on in group A and on A1 unit.

Operation in MAN mode (Manual mode)

With the A1 set to MAN mode, the light output for the groups A, B, C, and
D can be adjusted manually.
•
Select group(s) by doing one of the following:
• Press the A, B, C, or D group button [11] to select the
corresponding group.
• To select all groups, press one of the group buttons [11] twice.
When all groups are selected, the A1 will also control the lights
in group E and F (selected on the flash).
•
When a group is selected, do one or more of the following:
• Use the dial [13] to adjust the light output for the group.
The adjustment always starts from the current light output
setting (displayed as 0.0 above the group indicator) and the
adjustment value (e.g. +1.2) is momentarily shown above the
group indicator.
• Press the MODEL button [15] to turn on/off the modeling light
in the selected group.
• Press and hold the group button [11] to turn on/off the flashes
in the selected group.
• The display automatically returns to the main menu after a few
seconds.
Note:
If a light output cannot be set by the flash because it is outside its energy range, the A1
beeps to signal that the command was not executed. The light output of all flashes in
the selected group then remains unchanged.
www.profoto.com
17