Ir Slave; Flash Mode - Profoto B10 User Manual

•
DISCONNECT: This is only selectable if the Bluetooth is activated
and connected to the Profoto app. Can be selected to force
disconnection from the Profoto app without turning off Bluetooth.

IR slave

The IR SLAVE setting can be set to ON or OFF to activate or deactivate
the infrared slave sensor. Factory default setting is OFF.
NOTE
It is highly recommended to set IR SLAVE to OFF if other methods of triggering (e.g
AIR) is used.

Flash mode

The FLASH MODE setting adjusts the flash duration and color
temperature on the flash across the full power range. There are two
selectable settings, NORMAL and FREEZE. Factory default setting is
NORMAL.
•
NORMAL: Optimized for consistent color temperature across the
full flash power range. NORMAL is the best flash mode for most
types of shots.
•
FREEZE: Optimized for shortest flash duration across the full flash
power range. FREEZE is the best option for shots where the flash
is used to freeze fast action. When FREEZE is activated a FREEZE
indication shown on the main screen.
NOTE
The flash mode setting is only relevant when using the flash at shutter speeds within
the camera X-sync range. When shooting at shorter shutter speeds with High-Speed
Sync, there is not difference between the two settings.
See an overview of the flash duration and color temperature in NORMAL vs FREEZE
mode in the Specification section of this user guide.
www.profoto.com
21