JVC KD-S845 Service Manual page 8

2.2 CD mechanism section
2.2.1 Removing the CD mechanism control board
(See Fig.1 and 2)
(1) Unsolder the part a and b on the CD mechanism control
board.
(2) Remove the stator fixing the CD mechanism control board
and the damper bracket (To remove the stator smoothly,
pick up the center part).
(3) Remove the screw A attaching the CD mechanism control
board.
(4) Remove the CD mechanism control board in the direction
of the arrow while releasing it from the two damper bracket
slots d and the front bracket slot e.
(5) Disconnect the flexible wire from connector on the pickup
unit.
ATTENTION:
Turn the FD gear in the direction of the arrow to move the en-
tire pickup unit to the appropriate position where the flexible
wire of the CD mechanism unit can be disconnected easi-
ly.(Refer to Fig.2)
1-8 (No.49858)
CD mechanism assembly
D
h
Front bracket
Pickup unit
FD gear
Damper bracket
D
a
h
c
D
d
CD mechanism
e
A
control board
b
Fig.1
Flexible wire
Shift the lock
Fig.2