JVC KD-S845 Service Manual page 6

2.1.5 Removing the rear bracket
(See Fig.7)
• Prior to performing the following procedure, remove the front
panel assembly, front chassis assembly, heat sink and bottom
cover.
(1) Remove the one screws B, for screws C and three screws
D on the back side of the main body.
(2) Remove the rear bracket.
2.1.6 Removing the main board
(See Fig.8)
• Prior to performing the following procedure, remove the front
panel assembly, front chassis assembly, heat sink, bottom
cover and rear bracket
(1) Remove the two screws E attaching the main board.
(2) Disconnect the connector CN501 and remove the main
board.
2.1.7 Removing the CD mechanism assembly
(See Fig. 9)
• Prior to performing the following procedure, remove the front
panel assembly, front chassis assembly, heat sink, bottom
cover, rear bracket, main board and CD mecha board.
(1) Remove the three screws F.
1-6 (No.49858)
C
Rear bracket
D
Fig.7
Main board assembly
E
CN501
Fig.8
CD mechanism section
F
F
Fig.9
C
B
D
E
F
Top chassis