D-Link DES-3028 Cli Reference Manual page 49

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
create snmp host
Description
Parameters
Restrictions
Example usage:
To create an SNMP host to receive SNMP messages:
DES-3028P:4#create
auth_priv public
Command: create snmp host 10.48.74.100 v3 auth_priv
public
Success.
DES-3028P:4#
delete snmp host
Purpose
Syntax
Description
The create snmp host command creates a recipient of SNMP traps
generated by the Switch's SNMP agent.
<ipaddr>  The IP address of the remote management station that will
serve as the SNMP host for the Switch.
v1 – Specifies that SNMP version 1 will be used. The Simple Network
Management Protocol (SNMP), version 1, is a network management
protocol that provides a means to monitor and control network devices.
v2c – Specifies that SNMP version 2c will be used. The SNMP v2c
supports both centralized and distributed network management
strategies. It includes improvements in the Structure of Management
Information (SMI) and adds some security features.
v3 – Specifies that the SNMP version 3 will be used. SNMP v3
provides secure access to devices through a combination of
authentication and encrypting packets over the network. SNMP v3
adds:
 Message integrity  ensures that packets have not been
tampered with during transit.
 Authentication  determines if an SNMP message is from a
valid source.
 Encryption  scrambles the contents of messages to prevent
it being viewed by an unauthorized source.

noauth_nopriv Specifies that there will be no authorization and no
encryption of packets sent between the Switch and a remote SNMP
manager.
auth_nopriv  Specifies that authorization will be required, but there
will be no encryption of packets sent between the Switch and a remote
SNMP manager.
auth_priv  Specifies that authorization will be required, and that
packets sent between the Switch and a remote SNMP manger will be
encrypted.
<auth_sting 32>  An alphanumeric string used to authorize a remote
SNMP manager to access the Switch's SNMP agent.
Only Administrator-level users can issue this command.
snmp
Used to remove a recipient of SNMP traps generated by the Switch's
SNMP agent.
delete snmp host <ipaddr>
The delete snmp host command deletes a recipient of SNMP traps
generated by the Switch's SNMP agent.
host 10.48.74.100
44
v3