Advertisement
MANUAL
Starts and stops playback of the sequence.
DUAL + C1
Sets the tempo of the playback sequence. Up on the C1 ribbon controller is faster and down is slower.
[1] thru [16]
These represent the 16 steps of the sequencer. Press one of the 16 buttons to toggle the step on (lit) or off
(unlit). Lit steps will sound during sequence playback, while unlit steps will not.
[1] thru [16] + C1 (or a note on the keyboard)
Assigns the note in the selected step. Hold down the step button and press a note on the keyboard, or use
the C1 ribbon controller to select a note.
Step Button + Next Step Button (eg. [1] + [2])
Enters a tie between the two step buttons.
[1] thru [16] + C2
Adjusts the gate time of the selected step/note. This is the length of the note, where UP on the C2 ribbon
controller is longer, and DOWN is shorter.
DUAL + C2
Adjusts the gate time of all steps in the sequence. This is the length of all notes in the sequence, where UP
on the C2 ribbon controller is longer, and DOWN is shorter.
DUAL + [1] thru [16]
Selects a stored sequencer pattern.
DUAL + [1] thru [16] (long press)
Saves the current pattern to the button selected.
MANUAL + [1]
[1] thru [16]
Assigns the number of steps in the sequence (min 1, max 16).
MANUAL + [2]
[4] thru [12]
Sets the shuffle (default is 8). This plays the notes "out-of-time" or a little offbeat, the higher the number.
MANUAL + [3]
[1] thru [4]
Sets the scale (default is 2).
MANUAL + [15]
[1] thru [7]
Sets the step order, much like an arpeggiator. Choices are:
1
Normal (default)
2
Even/Odd reverse
3
Odd Only
4
Even Only
5
Odd Only Even Only
6
Even Only Odd Only
7
Random
7
Advertisement
