Control Module For Adaptive Cruise Control, Removing And Installing - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
10 - Adaptive Cruise Control Button - E357-
❑ Is integrated in the multifunction steering wheel.
❑ Removing and installing. Refer to ⇒ Communication; Rep. Gr. 91 ; Multifunction Steering Wheel; Right
and Left Multifunction Buttons on Steering Wheel - E441- / - E440- , Removing and Installing .
6.2 Control Module for Adaptive Cruise
Control, Removing and Installing
⇒ "6.2.1 Adaptive Cruise Control Module, Removing and Instal‐
ling, with Retaining Plate", page 42
⇒ "6.2.2 Adaptive Cruise Control Module, Removing and Instal‐
ling, from the Retaining Plate", page 43
⇒ "6.2.3 Control Module for Adaptive Cruise Control, Removing
and Installing at Adapter Frame", page 44
6.2.1 Adaptive Cruise Control Module, Re‐
moving and Installing, with Retaining
Plate
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Caution
This procedure contains mandatory replaceable parts. Refer
to component overview and parts catalog prior to starting pro‐
cedure.
Mandatory Replacement Parts
♦ Quick Release - Adapter Frame to Distance Regulation Con‐
trol Module
If the control module is being replaced, use the Vehicle Diagnostic
Tester and select the "Replacing" function for the respective con‐
trol module in "Guided Fault Finding".
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
– Remove the front bumper cover. Refer to ⇒ Body Exterior;
Rep. Gr. 63 ; Front Bumper; Bumper Cover, Removing and
Installing .
– Remove the screws -1-.
– Remove the Distance Regulation Control Module - J428- with
retaining plate -3-.
42
Rep. Gr.27 - Battery, Starter, Generator, Cruise Control